RWB Rule 1100GPH Submersible Bilge Pump – 12V

Next Generation compact, high capacity 1100 GPH (69 lpm) pump which is ideal as a boat bilge pump or a bait-box pump. Can also be used as a general purpose transfer pump. This highly efficient pump draws a low current while pumping out a massive volume of water. It is very compact and will fit in tight spaces. See dimensions below. Perfect for many different uses in a marine or work environment.

Get rid of bilge water without getting rid of your entire savings. A light and compact pump ideal for use ski-boats and small vessels. The Rule DA Submersible Bilge Pump provides ultimate pumping performance that helps keep your bilge clear of nuisance water. It’s built tough, easy to install, clean and maintain. The new model features optimised impeller provides greater flow with back flow prevention. Built-in thermal cut-off provides added protection for the pump and your vessel. 

Features

– Fully portable
– Fully submersible
– High efficiency, low draw ignition protected motor
– Manual operation
– Backflow prevention
– Can pump fresh or salt water
– Buit in thermal cut-out (TCO)
– Stainless steel shaft
– Snap off strainer
– Easy to install and operate
– Threaded discharge port
– Comes with instructions

Specifications

– 12 volt
– 3.7 amp power draw
– 69 litres per minute
– 4,140 litres per hour
– Maximum fluid temperature 60 degrees
– Straight threaded hose outlets for both 25mm (1”) and 28mm (1 1/8”)
– Compact – 112mm Height x 74mm Width x 64mm depth – not including discharge